Thank you!
We will contact you shortly.
Starting Guide Atom Extension DALI
Atom Extension DALI
Atom Extension DALI - a solution for controlling lighting devices using the DALI protocol. Allows you to turn on and adjust the brightness of up to 64 lamps with the appropriate interface.
Functional elements
1. 9-48V DCPower supply
2. CAN bus ensures synchronized operationof all Atom series devices
3. Device status indicator
4. DALI for connecting and controlling devices with a DALI interface
Technical specifications
Note : Technical specifications, wiring diagrams, input and output specifications and other technical information can be viewed on page Atom DALI
Installation guide
Important! During installation and operation, observe the general rules of electrical safety regarding the use of electrical appliances, as well as the requirements of regulations on electrical safety. It is strictly forbidden to disassemble a device to which any conductors are connected!
Important! Although the controller has built-in protection against incorrect power connection, and in this situation will not fail, we recommend that you pay attention to the correct polarity when connecting
3. i3-NET
If your system uses multiple controllers, connect them to a i3-NET network. Install the end terminators included in the equipment kit at the ends of the bus.
4. Connecting DALI devices
If you have DALI-controlled devices, connect them to the bus and connect them to the DALI connector. A suitable DALI power supply must be used to operate the bus.
Important! The maximum number of devices per bus should not exceed 64 devices.
5. Done. Turn on the power
Important! Check all connections. Make sure that the power supply, inputs and outputs are connected correctly.
List of typical problems and their solutions
LED indicators do not light
1. Check the supply voltage on the controller2. Check the polarity of the power supply
The device is turned on but not in the application settings
1. Make sure Wi-Fi and bluetooth are turned on on your smartphone or tablet2. Verify that the home network password is specified correctly in the controller settings3. Check the correct connection of the i3-NET bus
Didn’t find the answer to your question?
You can contact the technical support chatbot.Found a mistake on the site? Help us fix it!