Thank you!
We will contact you shortly.
Starting guide Atom I21
Designed to increase the number of input ports in the system.
Functional elements
1. 9-48V DCPower supply
2. CAN bus ensures synchronized operationof all Atom series devices
3. 5V and 3.3V connectorsfor sensors power supply
4. 21 x inputs with optocoupler modefor connecting switches and sensors
Technical specifications
Note : Technical specifications, connection diagrams, output specifications and other technical information can be viewed on our websiteAtom I21
Installation guide
Important! During installation and operation, observe the general rules of electrical safety regarding the use of electrical appliances, as well as the requirements of regulations on electrical safety. It is strictly forbidden to disassemble a device to which any conductors are connected!
Important! Although the controller has built-in protection against incorrect power connection, and in this situation will not fail, we recommend that you pay attention to the correct polarity when connecting.
3. i3-NET
Connect the extension controller to an i3-NET network. Install the end terminators included in the equipment kit at the ends of the bus.
4. Sensors power supply
A 5V and 3.3V controller outputs are provided to power the sensors.
Important! If the system uses sensors or actuators with other operating voltages, use additional power supplies or the power supply that powers the controller. If the system uses several power supplies - connect their "negative" terminals to each other.
5. Input connections
Connect sensors, switches and other devices to the inputs of the module. Connectors with screw clamps are used at the inputs of the expansion module, which ensures the convenience and reliability of connecting conductors with a cross-section of up to 2.5 mm2.
When connecting end devices, such as switches, digital sensors, dangerous interference can occur on long lines, so we use additional protection and improvement of the inputs using optocoupler mode.
Important! Inputs are numbered. "COM" is a common contact, it must be connected to the "plus" of the input power supply. Each input must be connected to a "dry contact" or "open collector" of a connected sensor, switch, or some other device with a "minus" of this power source.
6. Done. Turn on the power
Important! Check all connections. Make sure that the power supply, inputs and outputs are connected correctly.
List of typical problems and their solutions
The device is turned on, but is not visible in the application settings
1. Check the presence of supply voltage on the module2. Check the polarity of the power supply
The load does not turn on or reacts incorrectly
1. Check the correctness and reliability of the connection2. Check if the connected load operates properly
Didn’t find the answer to your question?
You can contact the technical support chatbot.Found a mistake on the site? Help us fix it!