Thank you!
We will contact you shortly.
Starting Guide Atom Extension I6DD4
Atom Extension I6DD4
Atom Extension I6DD4 - extension module for controlling modern lighting devices such as LED strips, or low-voltage LED lamps.
Functional elements
1. 9-48V DCPower supply
2. CAN bus ensures synchronized operationof all Atom series devices
3. 6 inputsfor connecting switches or temperature, air quality, leakage or other sensors
3. Device status indicator
4. 4 x MOSFET based dimmersto control DC loads
Technical specifications
Note : Technical specifications, wiring diagrams, input and output specifications and other technical information can be viewed on page Atom I6DD4
Installation guide
Important! During installation and operation, observe the general rules of electrical safety regarding the use of electrical appliances, as well as the requirements of regulations on electrical safety. It is strictly forbidden to disassemble a device to which any conductors are connected!
Important! Although the controller has built-in protection against incorrect power connection, and in this situation will not fail, we recommend that you pay attention to the correct polarity when connecting
3. i3-NET
If your system uses multiple controllers, connect them to a i3-NET network. Install the end terminators included in the equipment kit at the ends of the bus.
4. Connecting inputs
Connect sensors, switches and other devices to the inputs of the controller. Connectors with screw terminals are used at the inputs of the controller, which ensures the convenience and reliability of connecting conductors with a cross section of up to 1.5 mm2.
Important! The inputs are numbered and on each input there is a marking of the "common" output (marked with the letter "G") - this is a common contact, it is connected to the "minus" of the controller's power supply. All common contacts are interconnected, so when connecting switches with a multi-conductor cable, if necessary, it is enough to use only one connection to the “G” terminal.
5. Connecting outputs
Connect the devices controlled by the controller to the outputs. In the device, the outputs are combined into a group, the common output of the group is marked COM, and all outputs are numbered. Each group is implemented in the form of a 4-pin connector and is designed for connecting conductors with a cross-section of up to 2.5 mm2.
Examples of connecting loads to Atom Extension AD4 controllers are shown below.
OUT1-OUT4 - dimmers for controlling DC loads with a supply voltage of up to 48V and a consumption current of up to 4A.Allows you to control the brightness and color of LED strips, low-voltage lamps and adjust the speed of rotation of fans and DC motors.
6. Done. Turn on the power
Important! Check all connections. Make sure that the power supply, inputs and outputs are connected correctly.
List of typical problems and their solutions
LED indicators do not light
1. Check the supply voltage on the controller2. Check the polarity of the power supply
The device is turned on but not in the application settings
1. Make sure Wi-Fi and bluetooth are turned on on your smartphone or tablet2. Verify that the home network password is specified correctly in the controller settings3. Check the correct connection of the i3-NET bus
Didn’t find the answer to your question?
You can contact the technical support chatbot.Found a mistake on the site? Help us fix it!