Controller Selection

In the Device Manager, locate and select the Atom Extension RS232 controller from the list of available devices.

Connecting to Satel

● Click “Configure” and go to the RS-232 port settings.
● Enter the Satel security PIN code to confirm access.

Adding a Partition

 ● After successfully confirming the PIN code, click “Add Partition”.
● Enter the partition ID — it must match the ID set in the Satel configuration.
● Assign a name to the partition and optionally select a room.
● As a result, the partition will appear in the list.

Adding a Zone (Sensor)

● In the partition settings, click “Add Zone.”
● Enter the zone ID — it must match the ID in the Satel system.
● Assign a name, select the zone type, and specify the room.

Viewing and Configuration

● After adding a zone to a partition, all created partitions and zones will appear in the settings menu.
● This menu also allows you to view the current status of each partition and zone.
● All created partitions are displayed on the dashboard under the “Alarm” section.

Advanced Control

● After successfully configuring partitions and zones, their status and event history can be viewed in the advanced partition menu (zones are only displayed in this menu).
● Through the advanced menu, you can also:- Arm in full mode- Arm with zone bypass- Perimeter protection- Trigger immediate alarm- Disarm

As a result of completing the described steps, you will have a fully integrated Satel security system within the smart home environment. All partitions and zones will be visible in the app, their current status can be monitored, and security management — including arming/disarming, selecting protection modes, and viewing event history in real time — can be performed directly from the interface.